ThinkSystem SR665 Rear 2x7mm NVMe RAID Enablement Kit
This option kit comes with the following components.
1 One 7mm SATA/NVMe backplane (bottom)
2 One 7mm NVMe backplane (top)
3 Two 7mm tray fillers
4 One riser cage
5 One 7mm drive cage
6 One 7mm drive cage assembly
7 Two M3 screws
8 Eight M3.5 screws
9 One power cable (175 mm)
10 One signal cable (250 mm)
11 Three labels (PCIe 1-2 and 7mm label, NVMe label and PCIe 4-5 label)
12 One signal cable for slot 3 (380 mm)
NOTE
- The illustration in this document might differ slightly from your hardware.
Option installation
- To install the option, refer to:
- For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.
| Option installation | |
|---|---|
| To install the option, refer to “Hardware replacement procedures” and “Internal cable routing” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com. | |
| For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com. | |
Third Edition (October 2022)
© Copyright Lenovo 2022.
LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925