Skip to main content

ThinkSystem SD650, SD650-I V3 DWC M.2 Enablement Option Upgrade Kit

See this document for information about the ThinkSystem SD650, SD650-I V3 DWC M.2 Enablement Option Upgrade Kit.

This option kit comes with the following components.

ThinkSystem SD650, SD650-I V3 DWC M.2 Enablement Option Upgrade Kit

1 DWC M.2 backplane​

2 Two Torx T10 screws​

3 Six Phillips #2 screws​

4 M.2 drive mounting screw​

5 M.2 backplane cable​

6 M.2 backplane cold plate​

7 Putty pad (between M.2 backplane and M.2 drive)​

8 Putty pad (between M.2 backplane and processor cold plate)​

9 Putty pad (between M.2 backplane and M.2 backplane cold plate)​

10 Putty pad (between M.2 backplane cold plate and processor cold plate)​

11 Putty pad (between M.2 backplane cold plate and processor cold plate)​

NOTE
  • The illustration in this document might differ slightly from your hardware.
  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” and “Internal cable routing” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (February 2023)

© Copyright Lenovo 2023.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925