Skip to main content

ThinkSystem SD665, SD665-N V3 M.2 enablement kit

See this document for information about the ThinkSystem SD665, SD665-N V3 M.2 enablement kit.

This option kit comes with the following components.

ThinkSystem SD665, SD665-N V3 M.2 enablement kit

1 DWC M.2 backplane​

2 Two M3 screws​

3 Six M3x5 screws​

4 M.2 drive mounting screw​

5 M.2 backplane cable​

6 M.2 backplane cold plate​

7 Putty pad (between M.2 backplane and M.2 drive)​

8 Putty pad (between M.2 backplane and processor cold plate)​

9 Putty pad (between M.2 backplane and M.2 backplane cold plate)​

10 Putty pad (between M.2 backplane cold plate and processor cold plate)​

11 Putty pad (between M.2 backplane cold plate and processor cold plate)​

NOTE
  • The illustration in this document might differ slightly from your hardware.
  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” and “Internal cable routing” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (November 2022)

© Copyright Lenovo 2022.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925