Skip to main content

ThinkSystem SR630 V4 M.2 RAID B540d-2HS SATA/NVMe Enablement Kit

See this document for information about the ThinkSystem SR630 V4 M.2 RAID B540d-2HS SATA/NVMe Enablement Kit .

This option kit comes with the following components.

ThinkSystem SR630 V4 M.2 RAID B540d-2HS SATA/NVMe Enablement Kit

1 One M.2 RAID B540d module​

2 One MCIO x4 to MCIO x4 cable, 650mm​

3 One M.2 power cable, 700mm​

NOTE

  • The illustration in this document might differ slightly from your hardware.

  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

  • To make a front/rear M.2 drive assembly, match this option kit with two of the following option: "ThinkSystem V4 Hot Swap M.2 SATA/NVMe Drive Assembly Kit".

  • The M.2 RAID B540d module can be directly used for a E3.S drive bay chassis. If it is to be used for a 2.5-inch drive bay chassis, please remove its outmost adapter cage until the module is as shown below.
    The module for a 2.5-inch drive bay chassis

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (May 2021)

© Copyright Lenovo 2021.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925