Skip to main content

ThinkSystem SR650/a V4 M.2 RAID B540d-2HS SATA/NVMe Enablement Kit

See this document for information about the ThinkSystem SR650/a V4 M.2 RAID B540d-2HS SATA/NVMe Enablement Kit.

This option kit comes with the following components.

ThinkSystem SR650/a V4 M.2 RAID B540d-2HS SATA/NVMe Enablement Kit

1 One front M.2 drive cage and backplane assembly​

  • One front M.2 boot backplane
  • One front M.2 drive cage frame
  • One front M.2 controller board
  • One front M.2 drive cage
  • Two M.2 drive trays

2 One power cable, 700mm​

3 One MCIO x4 to MCIO x4 cable, 650mm​

4 One power cable, 1000mm​

5 One MCIO x4 to MCIO x4 cable, 900mm​

6 One 4-bay 2.5" drive filler​

7 Two 1-bay 2.5" drive fillers​

8 Drive sequence/type label​

  • One ThinkSystem SR650 V4 front M.2 (0-1) label, horizontal
NOTE

  • The illustration in this document might differ slightly from your hardware.

  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

  • To install the option, refer to
Server modelHardware installationInternal cable routing
SR650 V4Install the front M.2 drive cage and drive backplanesInternal cable routing
SR650a V4Install the front M.2 drive cage and drive backplanesInternal cable routing
Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (May 2021)

© Copyright Lenovo 2021.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925