ThinkSystem V4 Hot Swap M.2 SATA/NVMe Drive Assembly Kit
See this document for information about the ThinkSystem V4 Hot Swap M.2 SATA/NVMe Drive Assembly Kit.
This option kit comes with the following components.
1 One M.2 interposer
2 One M.2 heat sink and drive tray assembly
NOTE
- The illustration in this document might differ slightly from your hardware.
- To make a front/rear M.2 drive assembly, match two units of this option kit with one of the following options:
Option installation
To install the option, refer to
Server model Hardware installation SR630 V4 Assemble the rear M.2 adapter and drive SR650 V4 Assemble an M.2 drive assembly SR650a V4 Assemble an M.2 drive assembly SR850 V4 Assemble the rear M.2 interposer and drive SR860 V4 Assemble the rear M.2 interposer and drive
- For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.
| Option installation | |
|---|---|
| To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com. | |
| For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com. | |
First Edition (May 2021)
© Copyright Lenovo 2021.
LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925