ThinkSystem SR655 V3/SR665 V3 7mm RAID B540p-2HS SATA/NVMe Enablement Kit

See this document for information about the ThinkSystem SR655 V3/SR665 V3 7mm RAID B540p-2HS SATA/NVMe Enablement Kit.

This option kit comes with the following components.

`1` One riser 1/2 cage

`2` One Gen4 x16/x16/E riser card

`3` One 7mm drive cage support clip

`4` One 7mm drive cage for riser cage

`5` One 7mm drive cage

`6` One 7mm backplane top

`7` One 7mm backplane bottom

`8` Two 7mm tray fillers

`9` Two M3 screws

`10` Eight M3.5 screws

`11` Four labels

PCIe sequence label (1–2)
PCIe sequence label (4–5)
2U rear 7mm NVME label
2U rear 7mm SATA label

`12` One power cable, 210 mm

`13` One LP SlimSAS x4 to SlimSAS x4 cable, 125 mm

`14` One LP SlimSAS x4 to SlimSAS x4 cable, 250 mm

NOTE

The illustration in this document might differ slightly from your hardware.
The break lines indicate that the cable is not shown in its full length. Refer to the information in this document for the actual cable length.

Option installation

To install the option, refer to the applicable user guide:

Server model	Hardware installation	Internal cable routing
SR655 V3	Install the 7mm drive cage	Internal cable routing
SR665 V3	Install the 7mm drive cage	Internal cable routing

For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.

Give documentation feedback

1 One riser 1/2 cage​

2 One Gen4 x16/x16/E riser card​

3 One 7mm drive cage support clip​

4 One 7mm drive cage for riser cage​

5 One 7mm drive cage​

6 One 7mm backplane top​

7 One 7mm backplane bottom​

8 Two 7mm tray fillers​

9 Two M3 screws​

10 Eight M3.5 screws​

11 Four labels​

12 One power cable, 210 mm​

13 One LP SlimSAS x4 to SlimSAS x4 cable, 125 mm​

14 One LP SlimSAS x4 to SlimSAS x4 cable, 250 mm​