Skip to main content

ThinkSystem SR665 V3 Rear 2x7mm SATA/NVMe Enablement Kit

See this document for information about the ThinkSystem SR665 V3 Rear 2x7mm SATA/NVMe Enablement Kit.

This option kit comes with the following components.

ThinkSystem SR665 V3 Rear 2x7mm SATA/NVMe Enablement Kit

1 One riser 1/2 cage​

2 One Gen4 x16/x16/E riser card​

3 One 7mm drive cage support clip​

4 One 7mm drive cage for riser cage​

5 One 7mm drive cage​

6 One 7mm backplane top​

7 One 7mm backplane bottom​

8 Two 7mm tray fillers​

9 Two M3 screws​

10 Eight M3.5 screws​

11 Four labels​

  • PCIe sequence label (1–2)
  • PCIe sequence label (4–5)
  • 7mm drive type label SATA
  • 7mm drive type label NVMe

12 One power cable, 210 mm​

13 One LP SlimSAS x4 to SlimSAS x4 cable, 125 mm​

14 One MCIO x4 to SlimSAS x4 cable, 125 mm​

15 One MCIO x4 to SlimSAS x4 cable, 250 mm​

16 One LP SlimSAS x4 to SlimSAS x4 cable, 250 mm​

NOTE
  • The illustration in this document might differ slightly from your hardware.
  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” and “Internal cable routing” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (February 2023)

© Copyright Lenovo 2023.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925