Skip to main content

ThinkSystem V3 1U 2 x 2.5" NVMe Backplane Option Kit

See this document for information about the ThinkSystem V3 1U 2 x 2.5" NVMe Backplane Option Kit.

This option kit comes with the following components.

ThinkSystem V3 1U 2 x 2.5-inch NVMe Backplane Option Kit

1 One 2-bay 2.5-inch rear NVMe backplane​

2 One 2-bay 2.5-inch rear drive cage​

3 Two 1-bay 2.5-inch drive fillers​

4 One 2 x 2.5" rear NVMe HDD sequence label​

5 One power cable, 160mm/160mm​

6 One MCIO x8 to MCIO x4*2 cable, 200mm/240mm​

7 One MCIO x8 to MCIO x4*2 cable, 595mm/615mm​

NOTE
  • The illustration in this document might differ slightly from your hardware.
  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” and “Internal cable routing” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (February 2023)

© Copyright Lenovo 2023.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925