Skip to main content

ThinkSystem V3 1U 2 x 2.5" SAS/SATA Backplane Option Kit

See this document for information about the ThinkSystem V3 1U 2 x 2.5" SAS/SATA Backplane Option Kit.

This option kit comes with the following components.

ThinkSystem V3 1U 2 x 2.5-inch SAS/SATA Backplane Option Kit

1 One 2-bay 2.5-inch SAS/SATA rear backplane​

2 One 2-bay 2.5-inch rear drive cage​

3 Two 1-bay 2.5-inch drive fillers​

4 Drive sequence label​

  • One 1U 2 x 2.5" rear SAS/SATA HDD sequence label
  • One 1U 2 x 2.5" rear SATA HDD sequence label

5 One SlimSAS x4 to SlimSAS x4 cable, 810mm​

6 One SlimSAS x4 to Mini-SAS HD x4 cable, 270mm​

7 One SlimSAS x4 to LP SlimSAS x4 cable, 180mm​

8 One SlimSAS x8 to SlimSAS x4*2 cable, 270mm/590mm​

9 One power cable, 160mm/160mm​

NOTE

  • The illustration in this document might differ slightly from your hardware.

  • Cable Breakline The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” and “Internal cable routing” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (February 2023)

© Copyright Lenovo 2023.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925