Skip to main content

ThinkEdge SE360 V2 Riser Assembly (M.2 Riser + 7mm Backplane)

See this document for information about the ThinkEdge SE360 V2 Riser Assembly (M.2 Riser + 7mm Backplane).

This option kit comes with the following components.

ThinkEdge SE360 V2 Riser Assembly (M.2 Riser + 7mm Backplane)

1 One riser assembly with M.2 adapter, M.2 riser card and 7mm backplanes​

2 Two 7mm drive fillers​

3 One NVMe signal cable, system board to BP1/2, 130/175 mm​

4 One SATA signal cable, system board to BP2, 150 mm​

5 One power cable, I/O module board to BP1, 300 mm​

6 Three M3 screws​

NOTE
  • The illustration in this document might differ slightly from your hardware.

Option installation

Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (May 2021)

© Copyright Lenovo 2021.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925