ThinkEdge SE360 V2 Riser Assembly (PCIe Riser + 7mm Backplane)

See this document for information about the ThinkEdge SE360 V2 Riser Assembly (PCIe Riser + 7mm Backplane).

This option kit comes with the following components.

1 One riser assembly with PCIe riser card

2 Two 7mm drive fillers

3 One drive backplane (BP2)

4 One drive backplane (BP1)

5 One NVMe signal cable, system board to BP1/2, 130/175 mm

6 One SATA signal cable, system board to BP2, 150 mm

7 One power cable, I/O module board to BP1, 300 mm

8 Three M3 screws for riser assembly

9 Seven M3 screws for drive backplanes

NOTE

• The illustration in this document might differ slightly from your hardware.

Option installation

• To install the option, refer to:
  • "Install components to the left wing of riser assembly" in SE360 V2 User Guide
  • "Install the riser assembly to the node" in SE360 V2 User Guide
  • "Internal cable routing" in SE360 V2 User Guide
• For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.

Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (May 2021)

© Copyright Lenovo 2021.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925