ThinkEdge SE360 V2 Riser Assembly (PCIe Riser + PCIe Riser + Geotracking)

See this document for information about the ThinkEdge SE360 V2 Riser Assembly (PCIe Riser + PCIe Riser + Geotracking).

This option kit comes with the following components.

1 One riser assembly with PCIe riser card and PCIe cabled riser card, supporting geotracking

2 Three M3 screws

3 One PCIe riser signal cable, 140/120 mm

4 One PCIe riser power cable, 100 mm

NOTE

• The illustration in this document might differ slightly from your hardware.

Option installation

• To install the option, refer to:
  • "Install the riser assembly to the node" in SE360 V2 User Guide
  • "Internal cable routing" in SE360 V2 User Guide
• For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.

Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (May 2021)

© Copyright Lenovo 2021.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925