ThinkEdge SE455 V3 Riser2 Kit

See this document for information about the ThinkEdge SE455 V3 Riser2 Kit.

This option kit comes with the following components.

1 One PCIe riser 2 assembly

2 One extender for PCIe riser 2

3 Three low-profile fillers

4 Two M3 screws for extender

5 One Gen5 signal cable, 400mm/385mm

6 One Gen4 signal cable, 450mm/450mm

7 One power cable, 170mm

NOTE

• The illustration in this document might differ slightly from your hardware.

• The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.

Option installation

• To install the option, refer to:

  • "Install the PCIe riser card" in SE455 V3 User Guide

  • "Install a PCIe adapter" in SE455 V3 User Guide

  • "Install the PCIe riser assembly" in SE455 V3 User Guide

  • "Internal cable routing" in SE455 V3 User Guide

• For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.

Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (May 2021)

© Copyright Lenovo 2021.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925