ThinkEdge SE360 V2 Air Flow Sensor Assembly
See this document for information about the ThinkEdge SE360 V2 Air Flow Sensor Assembly.
This option kit comes with the following components.
1 One dust filter
2 One air flow sensor board
3 One air flow sensor cable, 150mm
NOTE
- The illustration in this document might differ slightly from your hardware.
The break lines indicate that part of the cable is hidden in the illustration. Refer to the information in this document for the actual cable length.
Option installation
- To install the option, refer to:
- "Install the processor air baffle and air flow sensor board" in SE360 V2 User Guide
- "Install the rear dust filter" in SE360 V2 User Guide
- For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.
| Option installation | |
|---|---|
| To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com. | |
| For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com. | |
First Edition (May 2021)
© Copyright Lenovo 2021.
LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925