Skip to main content

ThinkSystem ST50 Series / ST250 Series Rack Mount Kit

See this document for information about the ThinkSystem ST50 Series / ST250 Series Rack Mount Kit.

The option kits come with the following components.

ThinkSystem ST50 Series / ST250 Series Rack Mount Kit

1 One server rack tray

2 One cable tie

3 Four rubber safety pads

4 Two M6 x 16 screws

5 This publication

6 One right slide rail

7 One left slide rail

8 One CMA support bar

9 One cable management arm (CMA)

10 Six server brackets

NOTE
  • The illustration in this document might differ slightly from your hardware.

Option installation

  • To install the option, refer to the applicable user guide:
Server modelHardware installation
ST250 V2Install the server into the rails
ST250 V3Install the server to rack
ST50 V2Install the server to the rails
Option installation
To install the option, refer to “Hardware replacement procedures” in the server User Guide, which is available at Lenovo Docs https://pubs.lenovo.com.
For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support website https://datacentersupport.lenovo.com.

First Edition (October 2023)

© Copyright Lenovo 2023.

LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant to a General Services Administration (GSA) contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925