ThinkSystem ST250 V2 3.5" SATA/SAS 4-Bay Backplane Kit

ThinkSystem ST250 V2 3.5" SATA/SAS 4-Bay Backplane Kit

This document provides important information about ThinkSystem ST250 V2 3.5" SATA/SAS 4-Bay Backplane Kit.

Note:

• The illustration in this document might differ slightly from your hardware.

• The break lines indicate that part of the cable is hidden in the illustration. Refer to the description below for the actual cable length.

• 1 One power cable for lower 3.5-inch backplane
• 2 One power cable for upper 3.5-inch backplane
• 3 One SATA 0-3 to MSHD cable for lower backplane
• 4 One SATA 0-7 to MSHDx2 cable for lower and upper backplane
• 5 One HBA MSHD cable for lower backplane (450 mm)
• 6 One HBA MSHD cable for upper backplate (500 mm)
• 7 One Slimline to MSHDx2 cable for lower and upper backplane
• 8 One Slimline to MSHD cable
• 9 RAID flash power module extension cable
• 10 One 3.5-inch hot-swap drive backplane
• 11 One 3.5-inch drive cage
• 12 Four 3.5-inch drive fillers
• 13 One 9225 front system fan
• 14 One drive cage filler
• 15 Two drive filler alarm labels for optical disk drives
• 16 RAID flash power module holder for RAID 940-8i
• 17 RAID flash power module holder for RAID 9350-16i and 9350-8i

Option installation

• To install the option, refer to:

  • “Hardware replacement procedures” in ST250 V2 Maintenance Manual

  • “Internal cable routing” in ST250 V2 Maintenance Manual

• For the latest technical information including firmware and driver downloads, go to Lenovo Data Center Support.